- Parts are 3d printed in resin
- Assembly instructions are not included

- Most parts will come attached to their supports
- Be very careful when removing / cutting parts from the supports
- Some pieces are very small and delicate so take your time when removing them
- Super glue is recommended but it leaves you very little time to align parts
- If you choose to wash the parts use warm soapy water but do not leave the parts in the water too long or it will soften the parts.
- Let the parts air dry after washing

-If you find any uncured resin simply set the parts in the sun for just a few minutes but not too long
- Priming the parts is recommended